Location: >Electrical>Exterior Lights>Underwater Lights>Aqualuma>Aqualuma LED Underwater light. 3 Series blue LED light. AQLBN3P

Aqualuma 3 series LED underwater light. BLUE. AQLBN3P. Three LED series light in BLUE. Front face and sealing flange is 110 MM or 4.33 inches across. The overall length is 110.5 MM or 4.35 inches. Hole saw size is 60 MM or 2 3/8 inches. Operates on 12 or 24 volts DC. Operating current is less than 1/2 amp at 12 volts or less than .3 amps at 24 volts. Aqualuma sealant is supplied with every light. You may not and CANNOT use any other sealant than that provided with the light or it may void warranty. Now the company from down under is offering their lights to all boaters. They have come up with a revolutionary way to use LED (Light Emitting Doide) to brighten the underwater arena. The LED system provides several advantages over traditional underwater lights. For starters, Aqualuma manufacturers these thru-hull lights with a ONE piece housing that is made of high-impact polycarbonate. This is the same material that is used to make bullet-proof glass. The company has shown in it's testing labs that the light face can be even struck repeatedly with a heavy hammer without damage to the casing or LEDS. This rugged design is more than tough enough to take a pounding at sea or survive an accidental strike from debris while underway. It also makes Aqualuma the safe and reliable choice for use in vessels that exceed speeds of 40 MPH and they are pressure tested for water tightness up to 1,300 feet. The heart of Aqualuma/s system is a long-life, high-output LED light engine. They are available in white, blue, or green. The lights operate with very low DC power consumption. They draw .5 amps at 12 volts or .3 amps at 24 volts. Since they use LEDs rather than incandescent lamps, Aqualuma lights produce very little heat and can even be operated out of the water without damage. Aqualuma lights come with 13 feet of cable and are designed for easy, affordable installation. Since the housing is made from corrossion proof polycarbonate, no bonding wires or anodes are required and there is no lens seal to leak.These lights can be serviced from the inside of the boat, eliminating the need for costly and time consuming haul outs. These lights carry a two year warranty from the manufacturer.